Red Lion IndustrialPr 6000 Router - Manual (Page 173)

Software User Guide 173
Advanced Tab
Enter Port 1 (Required): This is a Client Primary Port address that GWLNX uses to connect to the Host Server Port. For
coordination with SSL Connections, this field should match the “TCP Listening Port” configured in Services‐>SSL Con‐
nections‐>SSL Client, to reach the specified remote SSL Host Server.
When using DIAL mode, and Gwlnx is configured for Dynamic TCP Server Listener Port, this field will specify the TCP
Port to listen on.
The recommended setting for this field is 1000.
Enter IP Address 2: This is a Client First Alternative IP Address that Gwlnx uses to connect to the Host Server.
Enter Port 2: This is a Client First Alternative Port Address that Gwlnx uses to connect to the Host Server Port.
Enter IP Address 3: This is a Client Second Alternative IP Address that Gwlnx uses to connect to the Host Server.
Enter Port 3: This is a Client Second Alternative Port Address that Gwlnx uses to connect to the Host Server Port.
Host Message Format: Following are the host message formats in supported Message Mode. The recommended set‐
ting for this field is Default.
Transparent Mode: Unused.
Visa Mode: This describes the format expected by the TCP host processor of Visa transactions. Visa Messages from the AMT/
POS device will conform to: STX ‐ PAYLOAD ‐ ETX ‐ LRC
Default: Use the current settings in the Gwlnx configuration.
Payload Only: Strip Visa header/trailers. Send only the Payload.
Payload ‐ ETX: Strip the Visa header and LRC block check.
STX ‐ Payload ‐ ETX ‐ LRC: Strip only the LRC block check.
STX ‐ Payload ‐ ETX ‐ LRC: Send the fully formatted Visa message.
Header Type: The TCP connection to a host may required length headers. This will optionally be prepended to the data
received from the serial side, for either transparent or Visa Mode. The recommended setting for this field is Default.
Default: Use current Gwlnx configuration.
None: Use no headers.
JBM Standard: Use JBM Standard Headers. This will prepend a Two Byte Length (2BL) Header to the data, indicating the num‐
ber of bytes in the message, not including the header bytes. Messages from the host must also have the 2BL header to be
received properly.
Example: With the Host Message Format set to STX‐Payload‐ETX, and just JBMSTD Headers used, the TCP message sent to the
Host will be: XX XX STX Payload ETX. Where XX XX would be the length of the payload data, plus 2 (STX and ETX bytes). If Pay‐
load was 296 bytes, then the 2BL would be 01 2A (in Hex).
Allow Early Connect: Only adjust this option if directed by Red Lion Technical Support. The recommended setting for
this field is Yes.
• Click on the Finish button and you will be directed to the Connect Table dialog window and the Connect Table
Properties table will be populated with the entered data.
• Click on the “Save” button for changes to be saved without activating the interface, the “Apply” button will save
your settings and apply them immediately. To revert to the previous defaults, click on the “Revert” button.