RADWAG HTY 60/H5/K Multifunctional Scales - Manual (Page 102)

102
Enter part mass
Estimate part mass
26.2. Local settings of the working mode
Local settings of the working mode <
Parts counting >
are accessible
on pressing a hot key < Local parameters>:
Save Mode Detailed description in ch. 24.2 of the user manual
Down-weighing Detailed description in ch. 24.3 of the user manual
Checkweighing Detailed description in ch. 24.4 of the user manual
Tare mode Detailed description in ch. 24.5 of the user manual
Labelling mode Detailed description in ch. 24.6 of the user manual
Statistics Detailed description in ch. 24.7 of the user manual
Automatic correction
of reference mass
Detailed description in ch. 25.2.1 of the user manual
Minimum reference mass Detailed description in ch. 25.2.2 of the user manual
26.2.1. Automatic correction of reference mass
It concerns the < Parts counting> working mode
Working mode <
Parts counting>
comprises a special function
< Automatic correction of reference mass>
, that can be used for
correcting the unit mass <SMP>. To enable the function in parameters you
need to:
• Enter parameter group <
Working modes>
according to ch.
24 of this manual, choose: „
Parts counting / Automatic
correction of reference mass”
and set appropriate option.