RADWAG HTY 60/H5/K Multifunctional Scales - Manual (Page 208)

208
37.1.3. Configuration of work modes of analogue modules
A work mode of analogue modules can be set using S1 switch according
to the drawings above ( table „configuration of analogue modules ”). Near
the S1 switch on the PCB you can find a description.
37.1.4. Connections to AN module
Drawing of connections of voltage output:
COLOURS OF WIRES
Colour Signal
Pink U
OUT
+
Gray GND
Yellow +24V DC
Green GND
Drawing of connections of current loop:
COLOURS OF WIRES
Colour Signal
White I
OUT
+
Gray GND
Yellow +24V DC
Green GND
Cable for analogue output