JLG 1250AJP Service Manual - Manual (Page 291)

SECTION 4 - BOOM & PLATFORM
3121171 – JLG Lift – 4-51
Figure 4-39. Boom Sensor Locations - Upper Length, Lower Length, & Tower Boom Angle - Sheet 2 of 2
HOSE LOOP
NOTE: ROUTE 3/4" TELE CYL EXTEND HOSE
THROUGH HOSE LOOP
ROUTE ALL SENSOR HARNESSES WITH
3/4" TELE CYL EXTEND HOSE BUT DO NOT
ROUTE THE SENSOR HARNESSES
THROUGH THE HOSE LOOP
ROUTE REMAINING TELE CYL HOSES WITH
3/4" TELE CYL EXTEND HOSE, BUT DO
NOT ROUTE THE REMAING HOSES
THROUGH THE HOSE LOOP.
USE TIE STRAPS TO FASTEN HARNESSES TO
TELE CYL HOSES AT LOCATIONS SHOWN
ATTACH SENSOR HARNESS
TERMINAL HERE
TYPICAL ON LEFT & RIGHT
SIDES OF BOOM
MAINTAIN 58" (147 cm) OF HARNESS
LENGTH FROM TURNTABLE HOSE LOOP
TO ALLOW FOR BOOM MOVEMENT
TYPICAL ON LEFT & RIGHT
SIDES OF BOOM
TURNTABLE HOSE LOOP
(ALL STRAP LOCATION
MEASUREMENTS ARE
TAKEN FROM THIS LOOP)
22" (56 cm)
STRAP LOCATION
27" (69 cm)
STRAP LOCATION
32" (81 cm)
STRAP LOCATION
36" (91 cm)
STRAP LOCATION
NOTE: DO NOT STRAP LEFT & RIGHT
TOWER BOOM ANGLE SENSOR HARNESSES
IN THIS TIE STRAP
0273121-M