JLG 1250AJP Service Manual - Manual (Page 322)

SECTION 4 - BOOM & PLATFORM
4-82 – JLG Lift – 3121171
If the tower boom length sensors are calibrated and
operating properly, the control system will verify the
tower boom length is less than 6 in. (15.2 cm). If the
tower boom is outside the length limit, the screen
will read:
14. When the machine passes all the configuration
checks, the screen will read:
15. Enter code 69286. The analyzer will read:
WHEN THE STABILITY CONTROL IS OFF THE MACHINE WILL TIP
IF USED INCORRECTLY.
16. Press the ENTER key to acknowledge the stability
control is turned off. The analyzer should read:
17. The control system will now allow main telescope
using the telescope control switch on the ground
console.