HYDAC CSI-F-10 - Manual (Page 15)

GSM Radio Module CSI-F-10 Page 15
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
4 Installation
4.1 Unpacking
The CSI-F-10 is supplied in a cardboard box. When taking delivery and when
unpacking the unit, check it for transit damage and report any damage to the carrier
immediately.
4.2 Installing the Unit
Only fit the unit in locations where the radio module can be operated without risk (see
Chapter 2. Safety).
When you are planning the layout for your system, allow sufficient space
underneath the unit and to the right of the unit, and distance between it and other
devices for cabling the peripherals and for connecting the communication cable.
Mount the GSM radio module using the mounting holes provided in the lower part
of the housing. To do this, the housing cover of the radio module must be
removed.
When installing in off-highway vehicles, construction & agricultural machinery etc,
avoid placing near to fuel tanks, tanks containing explosive substances or
electronic components which are inadequately screened.
Do not fit the antenna in enclosed metal constructions, such as a driver's console
or cab, or similar (Faraday screening effect).
Do not lengthen or shorten any antenna lines.
Note!
The condition for a stable GSM mobile radio connection is a good antenna signal.
If problems occur, change the position of the antenna or the mobile device. Also, if the
antenna plug is not tightly fitted this will cause a loss of signal!
The antenna connection must be protected from humidity and moisture.