HYDAC CSI-F-10 - Manual (Page 22)

GSM Radio Module CSI-F-10 Page 22
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
6 Commissioning
Note!
In order to be able to communicate later with the CSI-F-10 via GSM mobile radio, this
must first be configured. This means that the mobile phone numbers which are
authorized for access must be stored in the CSI-F-10 and appropriate permissions
assigned. In order to configure the GSM radio module CSI-F-10, first connect directly
with the GSM radio module CSI-F-10 (via CSI-B-2, HMG 510 or CMU 1000).
►See Chapter 6.3, 6.4 and 6.5!
6.1 Insert SIM card
Warning!
Only ever insert or remove the SIM card when voltage supply is disconnected.
• Remove the housing cover by unscrewing the 4 mounting screws.
• Press on the catch "PUSH OPEN" and lift the SIM card holder to the right.
•
Push the SIM card into the holder as per the diagram.
• Lift the holder again to the left, until it snaps back into the catch
• Replace the housing cover back onto the lower part of the housing.
The GSM radio module CSI-F-10 can only operate as such with a valid SIM card. This
card and the pin number for it can be obtained from your network operator or GSM
service provider.
For the direct transfer of data (online mode) you will need a SIM card which supports
the GSM data service and which is enabled for this. Some prepaid cards do not
support online direct transmission!
Use of pre-paid SIM cards!
Pre-paid SIM cards have a limited validity and limited credit. If the credit is used up or
the validity has expired, the function of the GSM radio module will no longer be
guaranteed!
Top up your pre-paid SIM card in good time!
Warning!
SIM cards and their contacts can easily be damaged by scratching or bending. When
handling the card, avoid placing any force on or touching the contacts.