HYDAC CSI-F-10 - Manual (Page 53)

GSM Radio Module CSI-F-10 Page 53
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
6.6.2 Connection Setup
• Start the HYDAC PC software CMWIN
• In the Units Menu, select the "CM Manager" option.
• If the Connection window does not open automatically, select
"Connection" in the menu bar of the CM Manager.
• Select the option "Modem Connection" option in the window that opens.
• Click on "Change" to open the window for the interface settings.
• Make the corresponding preselection for the port settings in the window that
opens under Interface selection.
• Select the relevant port address and Baud rate (9600 for GSM) under Interface
settings .
• Click "Refresh" to update the interfaces marked under Interface selection in
terms of availability.
• Click on “OK“ to apply the modified settings or “Cancel“ to discard these
changes. In either case you will then return to the Connection window.
• Click on "Change" to open the window for entering the telephone numbers.
• Enter the telephone number of the SIM card which is in the GSM radio module
CSI-F-10.
• In the Pin field enter the PIN code (if one has been assigned) for the SIM card
of the modem connected to the PC. If no PIN code has been assigned, then
leave the field empty.
Telephone number of the
SIM card in the CSI-F-10
PIN number of the SIM-
card in the PC modem