HYDAC CSI-F-10 - Manual (Page 74)

GSM Radio Module CSI-F-10 Page 74
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
• You can transfer and then edit the CM program currently available in the CSI-F-
10 to your PC with "Receive from device". This will however only work if the
CM program source code from the original creator has also been transferred
into the CSI-F-10.
If no source code is available in the CSI-F-10, then the following message will
appear:
• The "Online Debugging" function is a tool for observing the CM program as
well as for finding, diagnosing and eliminating possible errors in the CM
program and/or in the connected peripherals.
The following prerequisites must be fulfilled for this purpose:
- The CSI-F-10 must be connected with the PC and the CMWIN software.
- The CM program opened in CMWIN and the one active in the CSI-F-10
must be identical.
If the "Online Debugging" mode is active, then the following values will be
displayed for the relevant functions:
- Measured values
- Constants
- Switching status of logical links
- Date and time when initiating the corresponding event
The display in "Online Debugging" mode is shown in the following illustration,
by way of example: