HYDAC CSI-F-10 - Manual (Page 72)

GSM Radio Module CSI-F-10 Page 72
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
With "Perform cycle", you can start the simulation for a single processing
cycle and view the resulting status modifications of the actions afterwards.
With "Start autom. cycle" you can start a permanent, continuous program
simulation. You can change the input values however you like during the
simulation and observe the status modifications of the actions.
With "End autom. cycle" you can stop the permanent, continuous program
simulation.
Click on "Close“ to take you back to the CM Editor.
During the simulation, the assigned input values and action statuses are also
displayed in the Linked Functions window by means of corresponding
symbols.