HYDAC CSI-F-10 - Manual (Page 40)

GSM Radio Module CSI-F-10 Page 40
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
6.4.2.2 Connecting to the sensor by connection 1 (HSI address "a")
• Click on "Disconnect" in the Device box to break the existing PC connection
with the CSI-F-10.
• The following window opens:
• Then click on "No", so that the bus master is not reactivated.
• (!)
1
• Select Change in the Bus address line.
(!)
1 If you cancel at this stage and discontinue the connection to one of the connected sensors, after 5
minutes without communication a time-out occurs on the HSI bus.
This time-out causes the CSI-F-10 to be switched back independently to the bus master. This is
necessary so that the device can perform its monitoring function without being connected to CMWIN
both in the passive and active modes.