HYDAC CSI-F-10 - Manual (Page 93)

GSM Radio Module CSI-F-10 Page 93
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
9.4.8 Note Maximum
The Note maximum function outputs the largest value that the input
value has yet reached.
If the input value is less than the output value, then the output value
remains unchanged. If the input value is greater, then the output
value will be reset.
The maximum can be reset using the Boolean input x
2
. The input
value will be applied directly at the output for as long as this input is
"1".
Inputs: x
1
: Input value (Numerical).
x
2
: Reset (Boolean)
Outputs: y: (Numerical)
Parameters: -
9.4.9 Tabular Value
With the function Tabular value, the output value is obtained from a
parameterized number table. The input value functions as a number
of the table entry at the same time.
If the whole number value of the input is 0 or less, then the first
value of the table will be output; if it is 1, then the second value; and
so on up to the last tabular value. If the input value is greater than
the number of tabular entries, then the last table entry will be output.
As a basic rule, the input value will be rounded to a whole number.
The table is defined using the Table parameter. Each value must
have a line of its own at the time of entry. Empty lines are removed
automatically. The number of values will also be defined
automatically on the basis of the available lines. It must be between
2 and 20.
The Tabular value function can be used for example as a
downstream element of a division remainder in order to simulate
various values one after the other (see Chap. 9.3.5).
Inputs: x: Index of the selected tabular value (Numerical)
Outputs: y: Selected value (Numerical)
Parameters: p
1
: Table (values table)