HYDAC CSI-F-10 - Manual (Page 71)

GSM Radio Module CSI-F-10 Page 71
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
8.1.2 CM Program
• After "Display" is selected, a window opens listing all the functions used in the
CM program which is currently open, together with inscriptions and parameters.
The list can be printed out by selecting "Print".
Click on "Close“ to take you back to the CM Editor.
• With "Simulate", you can simulate and/or test the CM program that is currently
open. The Simulation window opens for this purpose. It is not necessary for
the CSI-F-10 to be connected for the simulation.
All of the input signals used in the CM program are listed one below the other
in the Name column in the left-hand part of the Simulation window.
You can assign a specific value to each input in the Input value column.
All of the actions used in the CM program are listed one below the other in the
Name
column in the right-hand part of the Simulation window.
The current status of each action is displayed in the Value column.
The cycle number of the last status modification is displayed in the Cycle
column.
The date and time of the last status modification is displayed in the Time
column.