Scaling recorder output, 4 scaling recorder output – INFICON UL5000 Dry Helium Leak Detector User Manual
Page 67
Description of the Menu
67
iina
74
e 0
6
.f
m
te
chn
ica
l ha
nd
boo
k
(1
40
8)
6.6.4.4
Scaling Recorder Output
•
>
>
>
Here the scaling of the recorder output can be adjusted. This adjustment is only valid
for the setting “LR lin” or ”LR log” (refer to Chapter
).
Example:
Chart recorder output: “LRlog”
Upper limit value is adjusted to 10
-5
(= 10V)
Scaled to 5 V /decade
Lower limit value consequently is 10
-7
(= 0 V)
Softkey 5:
?
Help
Softkey 6:
UL2xx Leak Ware
Gives the chance to control and read measurement values when connecting to a
computer.
Notice: The calibration function of the Leak Ware is not appropriate to operate with
the UL5000.
Please execute the function „STORE DATE“ in the operating mode „Single
Part Measurement“ for starting the record of the measured values.
Softkey 7:
ASCII
Gives the chance to use the UL5000 via a RS232 terminal.
Softkey 2:
Arrow up
Adjust decade of the upper limit value
Softkey No. 3: Arrow down
Scaling of the previously adjusted value in steps of 0.5, 1, 2, 2.5, 5, 10 Volt/decade. The
complete voltage range is 10 V. (Only for signal “LRlog”)
Softkey No. 6: Arrow up
Adjust decade of the upper limit value
Softkey No. 7: Arrow down
Scaling of the previously adjusted value in steps of 0.5, 1, 2, 2.5, 5, 10 Volt/decade. The
complete voltage range is 10 V. (Only for signal “LRlog”)