Chapter 3 sqs-242 software, 1 introduction, Chapter 3 – INFICON SQM-242 Thin Film Deposition Controller Card Software Operating Manual User Manual
Page 31
3 - 1
IP
N 07
4-
55
1-
P1
A
SQS-242 Operating Manual
Chapter 3
SQS-242 Software
3.1 Introduction
This chapter covers the minimum system connections and initial setup required to
run the SQS-242 software. Consult the SQM-242 operating manual for more
detailed instructions. See
.
Figure 3-1 SQM-242 Setup
1
Sensor Input Connections
Connect the BNC cables and oscillators from your vacuum chamber
feedthrough to the desired SQM-242 Card Input(s). Refer to Chapter 2 of the
SQM-242 manual for detailed instructions on system hookup to the SQM-242
card(s).
2
Source Output Connections
Connect the dual phone plug from the SQM-242 output jack to your
evaporation supply control input. Refer to Chapter 2 in the SQM-242 manual
for detailed instructions on wiring the SQM-242 output phone plug.
3
Digital I/O Connections
Digital I/O is not required for initial operation of the SQS-242 software. Perform
initial setup and checkout of the SQS-242 before connecting your digital I/O.
See
for detailed information on wiring the SQS-242 for digital I/O.