INFICON SQM-242 Thin Film Deposition Controller Card Software Operating Manual - Manual (Page 61)

3 - 31
IP
N 07
4-
55
1-
P1
A
SQS-242 Operating Manual
User: Dropdown box used to select an existing user, to edit their Access or
Password. It is not possible to edit or add a user name in the User dropdown. Use
the New SoftKey to create a new User. Use the Delete SoftKey to delete the
selected user.
Access: Assigns a program access level to the selected user. Generally speaking,
Supervisor (SUPV) provides access to all program functions. Technicians (TECH)
have access to a subset of functions. While User level access (USER) has access
to only those functions needed to run deposition processes. See the Access Tab
section to assign SUPV, TECH, and USER program capabilities.
Password: Each user will typically have their own password. When a password is
entered, a second box will appear for password confirmation. If the Password box
is left blank, no Password is needed for that user to login.
NOTE: User names and passwords are limited to A-Z, 0-9, _, -, and space.
Passwords are a maximum of 8 characters.
3.5.5.2 Access Tab
The Access tab allows Supervisors to assign which program functions are
available to each of the three Access Levels. When a program function is assigned
to a particular access level, it is automatically available to higher access levels.
In Figure 3-26 , every user has access to the File Process menu and the File Exit
menu. Only Supervisors have access to the Edit System and Edit Security menus.
The remaining menus are assigned TECH access. They will be available to TECH
and SUPV users, but not to USER access users.
The settings along the right side of the Main Form can be viewed by any user, but
values can only be edited by TECH or higher access.
Those who login with USER access can select and run processes, but they cannot
edit process parameters. TECHs can also select and run processes (because
those functions are assigned to a lower level access). However, TECHs can also
edit process parameters. Only Supervisors can change System Setup or Security
assignments.