JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 132)

9 Program editor
132
9.5 License dependance
The functions provided by the setup program depend on the registered license number. A
distinction is made between the following licenses:
•
Setup program with program editor (full version)
• Program editor
9.5.1 "Program editor" license
With the "Program editor" license, only the functions of the program editor and the program
generator configuration are available:
Functions
The functions of the program editor do not differ from those in the full version of the setup pro-
gram.
 Chapter 9.2 "Program schema", page 122
 Chapter 9.3 "Program simulation", page 127
With the ability to configure the program generators, certain parameters can be specified which
are important for the program schema (programming) and the program simulation:
•
Setpoint value limits and tolerance band limits for verification of the corresponding values
in the program schema
• Setpoint specification for program simulation with setpoint step or setpoint ramp
All other program generator parameters are editable, but will not be evaluated.
Data transfer between setup program and system
When transferring data from the setup program to the system, only program data is transferred.
During this process it is checked whether the setpoint values and possibly also the tolerance
band limits of the program are within the limits defined in the system. If this is not the case, an
error message is issued which offers various options to the user. The configuration data is not
transferred to the system (including the program generator configuration which was created for
verification and simulation).
When reading data from the system, the relevant configuration data (hardware, program
generator) – in addition to the program data – is also transferred to the setup program.
NOTE!
If the setup program is operated as a full version, the view can be switched so that only the
features of the program editor and of the program generator configuration are available (Menu
bar: Window > Program editor).
In the "Program editor" view, the options "Program generator“ or "Program generator with pro-
cess steps" are irrelevant.