JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 99)

99
6 Configuration
6.11.7 Tolerance band monitoring
This window is used to select the analog signal (actual value) to be monitored and to specify
the settings for an alarm in the event of a tolerance band infringement.
A tolerance band can be set for the first setpoint value (setpoint 1) of each program channel.
When the program is running, the actual value must be within the tolerance band. If it is not,
this constitutes a tolerance band infringement. In the event of a tolerance band infringement,
the relevant program is stopped until the actual value returns to a value that is within the band.
Setup dialog
Parameters
Parameter Selection/settings Description
Actual value Analog signal to be monitored
Inactive No signal selected.
Module (source of the analog signal) The analog signal of the relevant mod-
ule must be selected in the following
field.
Alarm type The alarm type is not set by default.
Collective alarm Alarm is used to form the collective
alarm.
Event Alarm results in an entry (event text) in
the event list.
Alarm at level High (1) Alarm at high level (1)
Low (0) Alarm at low level (0)