JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 140)

10 Online parameters
140
10.6 Calibrate / test
10.6.1 LED test
Setup dialog
Parameters
Parameter Selection/settings Description
Status LED To test the LED, click the required status
to select it (OFF, red, or green).
After selection, the LED enters the cho-
sen status immediately.
This function is used to test the electrical
function of the "Status" LED.
Bus Error LED To test the LED, click the required status
to select it (OFF, red, or green).
After selection, the LED enters the cho-
sen status immediately.
This function is used to test the electrical
function of the "Bus Error" LED.
Com1 LED To test the LED, click the required status
to select it (OFF, red, or green).
After selection, the LED enters the cho-
sen status immediately.
This function is used to test the electrical
function of the "Com1" LED.
Com2 LED To test the LED, click the required status
to select it (OFF, red, or green).
After selection, the LED enters the cho-
sen status immediately.
This function is used to test the electrical
function of the "Com2" LED.
Request To request the current LED status,
select the "Request" button. The current LED statuses are displayed.