JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 47)

47
5 Operation
Generator screen – program running
The appearance of (2), (3), (4), and (10) can be configured: selection of the signals (or of run-
ning time) and the color, assignment of name and unit.
(9)
(8)
(11)
(1)
(3)
(4)
(5)
(7)
(6)
(10)
(2)
(1) Program name and number of current pro-
gram section in channel 1
(2) Current setpoint value of program genera-
tor (here: setpoint value 1 of channel 1)
(3) Switch position of operating contacts (4) Remaining running time of program
(5) Skip to next program section of channel 1
(carried out for channel 2 and 3 at same
time if present)
(6) Abort program
(7) Skip to previous program section of chan-
nel 1 (carried out for channel 2 and 3 at
same time if present)
(8) Pause program
(9) Temporary change to program with pro-
gram editor
(10) Running time of program that has elapsed
(11) "Program running" display
NOTE!
Temporary changes to setpoint values on the multifunction panel are only displayed on the
generator screen for running programs. If the program is paused, temporary changes are ap-
plied, but not displayed. The changes do not take effect and are not shown on the generator
screen until the program continues to run.