Kinze 3140 Stack Fold Planter Rev. 7/14 User Manual

Page 143

Advertising
background image

TM

Model 3140

M0245-01

9/12

7-3

Troubleshooting

EDgEVAC SEED METER

PRObLEM

POSSIbLE CAUSE

SOLUTION

High seed count.

Wrong transmission setting.

Change transmission to desired rate.

High vacuum.

Adjust vacuum level to appropriate level.

Wrong seed disc.

Replace seed disc.

Singulator brush setting not aggressive
enough.

Adjust singulator brush.

Worn singulator brush.

Inspect brush and replace as required.

Seed leaking past wall brush.

Inspect wall brush condition and installation.
Replace as necessary.

Faulty vacuum gauge.

Check gauge line for dirt/obstruction.
Repair/replace vacuum gauge.

Poor seed spacing.

Obstruction in seed tube.

Clean seed tube.

Dirty/damaged seed disc.

Inspect seed disc for damage, foreign
material in orifices or seed treatment buildup
in recesses. Clean or replace as required.

Wrong vacuum setting.

Adjust vacuum to appropriate level.

Excess foreign material in seed.

Inspect and clean meter and seed discs.
Use clean, undamaged seed.

Incorrect singulator brush setting.

Adjust singulator brush to appropriate setting.

Inconsistent driveline.

Inspect drive components for rust,
misalignment, worn or damaged parts.
Replace/repair as required.

Toolbar not level or wrong height.

Adjust hitch to level toolbar and row units.

Planting too fast for conditions.

Reduce speed.

Rough field conditions.

Reduce speed.

Irregular seed population. Driving too fast.

Reduce speed.

Drive wheels slipping.

Reduce speed. Decrease row unit down
pressure spring settings.

Unable to achieve
desired vacuum level.

Tractor hydraulic flow set too low.

Increase flow to fan motor.

Incorrect hydraulic connections.

Check all hydraulic connections and hose
routings.

Damaged fan components.

Inspect motor and impeller for wear/damage
and repair/replace as necessary.

Vacuum hose pinched/kinked/blocked.

Inspect air lines for any damage or
obstruction. Clean air lines and manifold by
removing end cap from manifold and running
fan at high speed.

Vacuum hose loose/disconnected.

Inspect and reattach all air hoses.

Tractor not producing required hydraulic
flow/pressure.

Have tractor serviced by qualified technician.

Dirt in vacuum gauge line.

Check gauge line for dirt/obstruction and
clean.

Advertising