Kinze 3140 Stack Fold Planter Rev. 7/14 - Manual (Page 20)

M0245-01 Model 3140
2-6 9/12
TM
Machine Operation
LEVELINg THE PLANTER
For proper performance of the planter and row units, it is important that the planter frame and row unit parallel arms
operate approximately level. The toolbar should operate at a 20" to 22" height, measured from the planting surface
to the bottom of the toolbar.
When operating the planter, make sure the right and left lower link arms on the tractor are adjusted equally before
attaching the planter. After the planter has been lowered to the correct operating height, stop the tractor and stand
beside the planter and check to be sure the frame is level fore and aft. If the row units angle up or down, adjust the
center link on the tractor to level the machine.
It is important for the planter to operate level laterally. Tire pressure must be maintained at pressures specified and
drive wheel height must be adjusted equally. See “Wheel Module Height Adjustment”.
CONTACT wHEEL SPRINg ADJUSTMENT
There are two down pressure springs on each contact drive
wheel. The spring tension is factory preset and should require
no further adjustment.
The tension is set leaving 1" between the spring plug and the
mounting shaft as shown below.
1"
TRANSPORTINg PLANTER
wARNINg
All safety/warning lights, reflective decals, and SMV sign must be
in place and visible before transporting machine on public roads or
death, serious injury, and damage to property and equipment may
result. Check federal, state/provincial, and local regulations before
transporting equipment on public roads.
DANgER!
Contacting or coming close to power lines or other high energy
sources will cause death or serious injury. Keep away from power
lines or high energy sources at all times.
• Tow only with farm tractor rated and configured for equipment.
• Know your route and be aware of any obstructions.
• Follow all road and bridge load limit restrictions.
• Never exceed maximum transport towing speed of 20 mph (32 kph).