Lenze E84DGFCP - Manual (Page 10)

Communication manual 8400 motec PROFIBUS
About this documentation
Terminology used
10
L
EDS84DMOTPBUS EN 3.0 - 11/2011
1.3 Terminology used
Term Meaning
Controller Lenze frequency inverter of the "Inverter Drives 8400 motec" product series
Standard device
Drive unit
Communication unit
Wiring unit
The controller 8400 motec consists of the following modules: "Drive unit",
"communication unit" and "wiring unit".
• The drive unit is available in various power classes.
• The communication unit is available in the following versions:
–No fieldbus
–AS-i option
–CANopen option
–PROFIBUS option
–PROFINET option
–EtherCAT option
• The wiring unit provides flexible connection options for an easy integration
into the power supply of the machine.
»Engineer« Lenze PC software supporting you during the "Engineering" process
(parameterisation, diagnostics, and configuration) throughout the entire life
cycle, i.e. from planning to maintenance of the machine commissioned.
Code Parameter by means of which you can parameterise or monitor the controller. In
common parlance, this term is also referred to as an "index".
Subcode If a code contains more than one parameter, these parameters are stored in
"subcodes".
In this documentation a slash "/" is used as a separator between code and
subcode (e.g. "C00118/3").
In common parlance, this term is also referred to as a "subindex".
Lenze setting These are settings the device is preconfigured with ex works.
Basic setting
HW
Hardware
SW Software