15 index, Index, Communication manual 8400 motec profibus – Lenze E84DGFCP User Manual
Page 97
EDS84DMOTPBUS EN 3.0 - 11/2011
L
97
Communication manual 8400 motec PROFIBUS
Index
15
Index
A
Abort of data transfer by the controller (DP-V0)
Access to process data
Active station address (C13864)
Acyclic data transfer (DP-V1)
Addressing of Lenze parameters/parameter data
All words from master (C13851)
All words from standard device (C13853)
All words to master (C13850)
All words to standard device (C13852)
Analog input information
Application as directed
Application notes (representation)
Application of the communication unit
Approvals
B
Baud rate
Baud rate (C13863)
Before initial switch-on
Bus cable length
Bus counter (C13862)
Bus status (C13861)
Bus termination
C
C01501 | Resp. to communication error with MCI
C01503 | MCI timeout
C13850 | All words to master
C13851 | All words from master
C13852 | All words to standard device
C13853 | All words from standard device
C13860 | Settings
C13861 | Bus status
C13862 | Bus counter
C13863 | Baud rate
C13864 | Active station address
C13865 | Display:Most recent PRM data
C13866 | Display:Most recent CFG data
C13867 | Display: Most recent diagnostic data
C13880 | Reaction on communication failure
C13881 | Monitoring time: Data exchange
C13882 | Monitoring time: Watchdog
C13885 | Delete process data
C13886 | Set ext. diagnostic bit in case of
C13887 | Suppress signalling diag. mess. upon
C13899 | Station address
C13900 | Firmware product type
C13901 | Firmware compilation date
C13902 | Firmware version
C13920 | Display: DIP switch setting
C13950 | Module internal communication status
Cable length
Codes
Commissioning
Communication channels
Communication medium
Communication profile
Communication time
Communication-relevant parameters of the operating
system
Configuration for the host (master)
Configuration of the master
Configuring the host (master)
Configuring the port interconnection in the
»Engineer«
Conformities
Connection establishment between master and slave
(DP-V1)
Conventions
Conventions used
Copyright
D
Data transfer
Data transfer abort by the master (DP-V0)
Delete process data (C13885)
Device- and application-specific safety instructions
Device data base file
Device protection
Diagnostic data
Diagnostic message
Diagnostic messages
Diagnostics
Diagnostics with the »Engineer«
Digital input information
DIP switch positions for setting the station address
DIP switch settings
Display
DIP switch setting (C13920)
Most recent CFG data (C13866)
Most recent diagnostic data (C13867)
Most recent PRM data (C13865)
Document history
DP-V0
DP-V1
DRIVECOM
DRIVECOM parameter data channel (DP-V0)
E
Electrical installation
Error:Lenze settings loaded (error message)
Error code of the Inverter Drive 8400