Lenze DDS Function library IOSystem - Manual (Page 22)

4.2 L_IOParAlnModule − Parameterisation function
Function library LenzeIOSystem.lib
Function blocks
4−4
L
LenzeIOSystem.lib EN 1.7
4.2 L_IOParAlnModule − Parameterisation function
By means of the L_IOParAInModule function block, the analog input modules (EPM−T310 / 311 /
T312) are parameterised. Parameterisation is started by a high edge on the input
bExecute.
Each module has four channels, whereby each channel can be set individually.
The following is provided:
·
Voltage measurement
·
Current measurement
·
Resistance measurement
·
Temperature measurement
On the output of the function block, the transmission status and the information on the connected
modules are displayed.
BEnableDiagnosticAlarm *
bEnableAnalogInterrupt
BySampleRate_CH1 *
L_IOParAInModule
bExecute
byNodeAdr
nState
CTRL
byAnalogModuleNo
byFunctionInput_CH1
ByTriggerSelection_CH1 *
byFunctionInput_CH4
BySampleRate_CH4 *
BySelectionFcn_CH4 *
BySelectionFcn_CH1 *
ByTriggerSelection_CH4 *
ByTriggerValue_CH4 *
ByHysteresis_CH1 *
ByHysteresis_CH4 *
ByTriggerValue_CH1 *
EPM-T110
Ixxxh
EPM-T111
* Input/function is exclusively supported by type EPM−T310.