Lenze PLC Designer V2.x - Manual (Page 106)

PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
9400 HighLine - "LAS_40_INTF_Can_94HL_TabPos" sample project
106
L
1.3 EN - 07/2012
8.4.3 Program structure in the »PLC Designer«

How to proceed:
1. In the »PLC Designer«, open the "LAS_40_INTF_Can_94HL_TabPos.pro" sample
project.
2. Load the project to the IPC and Go online.
8.4.3.1 Control configuration
 The CAN master (ID = 0) is the control section of the system configuration
 Below the CAN master the 9400 HighLine (CAN node ID = 5) is attached.
– The 9400 HighLine is embedded in the form of a device-independent EDS file
(LenzeDrive_Can1_4Word).
 Two PDOs for CAN-Input and CAN-Output are used, respectively.
 The transmission mode is sync-controlled (10 ms).