Lenze PLC Designer V2.x - Manual (Page 51)

1.3 EN - 07/2012
L
51
PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
8400 StateLine - "LAS_40_INTF_Can_84SL_Speed" sample project
Control/status panel
Further information on the FB can be found in the following section:
 L_S84_ActuatorSpeedSL - actuation of the 8400 StateLine controller
( 238)
 Actuation of the controller  Status of the controller
CAN address
Number of the CAN master
Switch on drive after mains switching
Enable drive
Activate quick stop
Activate fixed speed (Jog 1)
Activate fixed speed (Jog 2)
Set external error
Reset error
Set clockwise (CW) rotation/counter-clockwise
(CCW) rotation
Select speed setpoint in [%]
CAN communication OK
Error active
Controller ready
Minimum speed limit value not reached
Drive enabled
Actual speed value
CAN status