Lenze PLC Designer V2.x - Manual (Page 158)

PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
8200 vector - "LAS_40_INTF_Can_82_Speed" sample project
158
L
1.3 EN - 07/2012
Control/status panel
Further information on the FB can be found in the following section:
 L_S8V_ActuatorSpeed - actuation of the 8200 vector controller
( 267)
 Actuation of the controller  Status of the controller
CAN address
Number of the CAN master
Enable drive
Activate quick stop
Activate fixed speed (Jog 1)
Activate fixed speed (Jog 2)
Set external error
Reset error
Set clockwise (CW) rotation/counter-clockwise
(CCW) rotation
Select speed setpoint in [%]
CAN status
CAN communication OK
Error status
Controller ready
Controller is enabled
Quick stop status
Speed is zero
Actual speed value