SATEC PM130 PLUS Manual - Manual (Page 106)

‎Chapter 6 Device C O N T R O L A N D U P G R A D I N G
Resetting A C C U M U L A T O R S , M A X I M U M V A L U E S A N D F I L E S
106 PM130 PLUS Powermeter Series
Chapter 6 Device Control and
Upgrading
This section describes operations on the meter you can perform from the
front display or via PAS. To access device control options from PAS, you
should have your meter online.
6.1 Resetting Accumulators, Maximum Values and Files
Using the Front Display
Select the rst entry from the main menu. See Viewing and Changing
Setup Options in Chapter 3 for information on configuring parameters via
the front display.
To reset the desired values:
1. Highlight the middle window by
pressing briefly the SELECT button.
2. Select a reset entry by scrolling through the list with the UP
and DOWN arrow buttons.
3. Press the SELECT button briefly to highlight the lower item.
4. Press and hold the ENTER button for 5 seconds.
5. Release the button.
The do entry is replaced with done
showing the operation is complete.
Table 31 shows the reset options available from the front display.
Table 31: Front Display Reset Options
Display Label Description
EnrG Clears all total energies
dnd Clears all maximum demands
P.dnd Clears power maximum demands
A.dnd Clears ampere and volt maximum demands
Lo.Hi Clears Min/Max log
Cnt Clears all counters
Cnt1 – Cnt4 Clears counter #1-#4
diAG Clears device diagnostics
Using PAS
Ensure that the On-line button on the PAS toolbar is checked, and then
select Reset from the Monitor menu.