SATEC PM130 PLUS Manual - Manual (Page 126)

‎Chapter 8 Retrieving A N D S T O R I N G F I L E S
Exporting F I L E S
126 PM130 PLUS Powermeter Series
3. Select a folder where you want to store your exported files,
type a file name that identifies your files, select a file output
format, and then click on the Save button.
4. The PQDIF files are commonly recorded in compressed format.
If you do not want your files to be compressed, uncheck the
Compress box before saving the file.
In COMTRADE format, each waveform event is recorded into a separate
file.
PQDIF file names are followed by a timestamp of the first event recorded
to the file, and may look like follows:
12KVSUB_20040928T133038.pqd.
Automatic Converting
PAS allows you to automatically convert data logs into PQDIF format at
the time you upload data from your devices via the Upload Scheduler.
To automatically convert your data log tables into PQDIF format:
1. Open the Upload Scheduler.
2. Highlight a desired device site with the left mouse button, and
then click on the Export button.
3. Check the Enabled box for a data log or a waveform log table
you want to automatically convert at the upload time.
4. Highlight the Record to… row for the selected table and click
on the Browse button.
5. Select a folder where you want to store converted files, type in
the converted file’s name, select a desired output file format,
and then click on Save.
6. Repeat the same for all tables you wish to be converted.
7. Click OK.