SATEC PM130 PLUS Manual - Manual (Page 158)

‎Appendix G Device Diagnostic C O D E S
158 PM130 PLUS Powermeter Series
Appendix G Device Diagnostic Codes
Table 40: Device Diagnostic Codes
Diagnostic
Code
Diagnostic
Message
Description Reason
2 dAtA Memory/Data fault Hardware failure
3 rSt Hardware watchdog reset Hardware failure
5 CPU CPU exception Hardware failure
6 runt Run-time software error Hardware failure
7 tout Software watchdog
timeout
Hardware failure
8 PWr.UP Power Down/Up Normal power-up sequence
9 rStrt Warm restart External restart via
communications or by
firmware upgrade
10 ConF Configuration reset Corrupted setup data has
been replaced with the
default configuration
11 rtc RTC fault The clock time has been lost
13 Lo.bAt Low battery (with a
battery backup unit)
Battery replacement is
required
15 EEPr EEPROM fault Hardware failure
See Diagnostics Display in Chapter 3 for more information on the PM130
PLUS built-in diagnostics.