SATEC PM130 PLUS Manual - Manual (Page 4)

4 PM130 PLUS Powermeter Series
Quick Start Guide
This section can be used by a licensed electrician to install and perform basic
PM130 PLUS setup. For more detailed PM130 PLUS setup and use
instructions, see the following chapters in this manual.
This quick start guide will assist you to have the unit running for the first
time.
During the operation of the meter, hazardous voltages are present in
the input terminals. Failure to observe precautions can result in
serious or even fatal injury, or damage to equipment.
For complete and accurate in-depth instructions, refer to the following
chapters in this manual.
1. Installing the PM130 PLUS
Mounting the PM130 PLUS Unit
To mount the PM130 PLUS:
1. Position the PM130 PLUS unit in the square or round
cutout. If two PLM130 PLUS are positioned side by
side, take care of proper interval between them.
2. Attach the PM130 PLUS unit using washers and
nuts. Make sure that the unit is securely attached
into the wall or cabinet fixture.
Mounting the PM130 PLUS (Square or Round Cut-out)