SATEC PM130 PLUS Manual - Manual (Page 112)

‎Chapter 6 Device C O N T R O L A N D U P G R A D I N G
Upgrading D E V I C E F I R M W A R E
112 PM130 PLUS Powermeter Series
4. Point to the firmware upgrade file for your meter, click Open,
and then confirm upgrading the meter.
5. You are asked for the password regardless of the password
protection setting in your meter. Type the meter password,
and click OK. If you did not change the password in the meter,
enter the default password 0.
6. Wait until PAS completes upgrading your device. It takes about
3-4 minutes at 115,200 bps to download the file to the meter.
7. After upgrading firmware is completed, the meter restarts, so
communications can be temporarily lost. You may need to wait
a short duration until PAS restores a connection with your
device.