SATEC PM135 Manual - Manual (Page 106)

‎Chapter 5 Configuring the PM135 Configuring Recorders
106 PM135 Powermeter Series
4. Select the maximum number of
records you want to be recorded in
the file.
5. Click OK, and then send your new
setup to the meter, or save to the
device database.
To define the contents of the file:
1. Highlight the data log file row with
the left mouse button, and then
click on the Setup Recorder
button, or click on the Data
Recorder tab and select the
corresponding log number.
Figure ‎5-20: Log Setup Dialog Box – Data Recorder Tab
2. Configure the list of parameters to
be recorded in a log file. You are not
allowed to select more parameters
than you defined when configuring
your file. Refer to Appendix D for a
list of available parameters.
3. For your convenience, PAS follows
your selection and helps you
configure a series of the neighboring
parameters: when you open the
Group box for the next parameter,
PAS highlights the same group as in
your previous selection; if you select
this group again, PAS automatically
updates the Parameter box with
the following parameter in the
group.
4. Add the name for your data log file
in the Name box. It will appear in
the data log reports.
5. Save your new setup to the device
database, and send it to the meter.