SATEC PM135 Manual - Manual (Page 66)

‎Chapter 4 Using PAS Software Setting Up the Meter
66 PM135 Powermeter Series
connection before announcing an
error.
Figure ‎4-4: Configuration Dialog Box – Connection Tab
6. In the Retries box, specify the
number of retries PAS will use to
receive a response from the meter if
communications fail.
7. Click OK.
4.4 Setting Up the Meter
Preparing Setups for the Meter
PAS allows you to prepare setup data for your meter off-line without the
need to have it connected to your PC.
To prepare a setup for your meter:
1. Select the device site from the list
box on the PAS toolbar.
2. Select the desired setup group from
the Meter Setup menu. Click on
the tab with the setup you want to
create or modify.
3. Fill in the boxes with the desired
configuration data for your meter.
4. Click the Save as… button to store
the data to the meter site database.
5. Click OK.
Always set up and store the Basic Setup data to the site
database first. PAS uses this data as a reference when
arranging other meter setups.
To save your setup to another site database:
1. Click the Save as… button.