SATEC PM135 Manual - Manual (Page 92)

‎Chapter 5 Configuring the PM135 General Meter Setup
92 PM135 Powermeter Series
Configuring the Display
This setup allows configuring the meter display.
Using the Front Display
Select the Display Setup entry from the Device Setup menu. See
Viewing and Changing Setup Options in Chapter 3 for information on
configuring parameters via the front display.
Device Setup
Reset
Real Time Clock
Display Setup
Basic Setup
Device Options
COM1 Setup
COM2 Setup
Table 16: Display Setup Options
Display Parameter Options Default Description
Auto Scroll Auto Scroll interval None,
2-15 sec
None Defines the scroll interval
for the main data display
or disables auto scroll
Auto Return Auto Return to Data
Display screen
diS = disabled,
En = Enabled
Enabled Enables automatic return
to the main display if no
buttons are pressed for 5
minutes
Backlight Display Backlight Continuous, 1-
10 min.
1 Defines the backlight
duration to be "ON" in idle
operation
Diagnostics LED Diagnostics indication
LED
Disabled,
Enabled
Disabled Enables the diagnostic
LED
Phase Powers Phase Powers display
mode
Disabled,
Enabled
Disabled Disables or enables phase
powers in the main
display
Fundamental
Powers
Fundamental component
display mode
Disabled,
Enabled
Disabled Disables or enables
fundamental values in the
main display
Contrast Display Contrast 1-25 15 Sets LCD contrast
Load Bar Scale, A Reference load current
for LED bar graph
0-10,000A
(0 = CT
primary
current)
0 0 Defines the nominal
load
(100%) level for the bar
graph display