Rockwell Automation 23P PowerFlex DC Stand Alone Regulator and Gate Amplifier - Manual (Page 39)

Rockwell Automation Publication 23P-UM001D-EN-P - July 2012 39
Stand Alone Regulator Installation, Wiring and Configuration Chapter 2
Figure 13 - Burden Resistor Jumpers (J4 and J5), Binary Gain Amp DIP Switches
(SW3 and SW4), and External Burden Resistor Terminal Block (XCT) Locations
Figure 14 - Binary Gain Amp DIP Switch to Bit Layout
SW3 SW4
J5 J4
0VI RCT XCT
MSB LSB
ON
Off
On
Pulse Transformer Board
Burden Resistor
Jumpers External Burden Resistor
Terminal Block (XCT)
Binary Gain Amp
DIP Switches
MSB LSB
Bit 11 Bit 10 Bit 9 Bit 8 Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
IMPORTANT The labels on DIP switches SW3 and SW4 do NOT correspond to the bit
numbers used to set the amplifier gain.
ON
1 2 3 4 1 2 3 4 5 6 7 8
SW3 SW4