Rockwell Automation 23P PowerFlex DC Stand Alone Regulator and Gate Amplifier - Manual (Page 74)

74 Rockwell Automation Publication 23P-UM001D-EN-P - July 2012
Appendix A Specifications
Gate Coupler Assembly Mounting Instructions
The Gate Coupler Assembly is an open type construction and is intended to be
installed on a flat surface in a suitable enclosure.
• Mount in a clean, dry location. Contamination from oils, corrosive vapors
and abrasive debris must be kept out of the enclosure.
• Mount the unit in a vertical or horizontal position depending on the panel
layout.
• It is permissible to have all gate leads exit from one side of the assembly if
needed, (two pairs per exit port), or one pair of gate leads from each exit
port.
Figure 35 - Minimum Mounting Clearances
Gate Coupler
Assembly
0.75 in.
19 mm
0.75 in.
19 mm
0.75 in.
19 mm
4.5 in.
114 mm
Extra clearance
required at the
input port for
the connector.