Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) - Manual

Publication 20C-IN001D-EN-P
PowerFlex® 700H to 700S Phase II
Control Conversion - Frames 9…14
Installation Instructions
!
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the
following.
!
ATTENTION: To avoid an electric shock hazard, verify that the
voltage on the bus capacitors has discharged completely before
servicing. Check the DC bus voltage at the Power Terminal Block by
measuring between the +DC and -DC terminals, between the +DC
terminal and the chassis, and between the -DC terminal and the
chassis. The voltage must be zero for all three measurements.
!
ATTENTION: HOT surfaces can cause severe burns. Do not touch
the heatsink surface during operation of the drive. After
disconnecting power allow time for cooling.
!
ATTENTION: Hazard of permanent eye damage exists when using
optical transmission equipment. This product emits intense light and
invisible radiation. Do not look into SynchLink fiber-optic ports or
SynchLink fiber-optic cable connectors.
!
ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing or repairing this assembly.
Component damage may result if ESD control procedures are not
followed. If you are not familiar with static control procedures,
reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection
handbook.
!
ATTENTION: The sheet metal cover and mounting screws on the
ASIC Board located on the power structure are energized at (-) DC
bus potential high voltage. Risk of electrical shock, injury, or death
exists if someone comes into contact with the assembly.