Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) - Manual (Page 10)

Publication 20C-IN001D-EN-P
10
6. Make the following connections on the 700S Phase II Control cassette:
– Connect the 10 conductor ribbon cable to P6
– Connect the 40 conductor ribbon cable to P1
– Connect the 30 conductor ribbon cable to P2
7. Slide the 700S Phase II Main Control Cassette onto the mounting bracket
and tighten the two mounting screws.
=
10 conductor ribbon cable
40 conductor ribbon cable
30 conductor ribbon cable
Note: Ribbon cables not
shown for clarity only