Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) - Manual (Page 2)

Publication 20C-IN001D-EN-P
2
What This Kit Includes
•
Phase II control assembly mounting plate, bracket and hardware
•
40 conductor ribbon cable
•
30 conductor ribbon cable
•
Status cable
•
10 conductor ribbon cable for frame 9 drives
•
10 conductor ribbon cable for frame 10…14 drives
•
Power Interface circuit board and hardware
•
Voltage Feedback circuit board and hardware
•
Phase II control cassette (required, ordered separately)
•
24V Common Mode Filter circuit board and hardware for frame 10…14
drives
•
Twisted pair wires and connectors for 24V Common Mode Filter circuit
board for frame 10…14 drives
•
EMI shield and hardware for frame 10…14 drives
Tools That You Need
•
Phillips
®
screwdriver
•
POZIDRIV
®
screwdriver
•
Torx Head screwdriver
Phillips
®
and POZIDRIV
®
are registered trademarks of Phillips Screw
Company.
What You Need to Do The steps to complete the PowerFlex® 700H to 700S Phase II control
conversion are different for frame 9 size drives versus frame 10…14 size drives.
Refer to “
Frame 9 Conversions Only ” for frame 9 conversion instructions. Refer
to Frame 10…14 Conversions Only on page 17 for frame 10…14 conversion
instructions.
Frame 9 Conversions Only Complete these instructions if you are converting a PowerFlex frame 9 size
drive only:
❐ Step 1: Remove power from the drive
❐ Step 2: Remove drive covers
❐ Step 3: Remove 700H control assembly
❐ Step 4: Remove 700H Fiber Optic Adapter circuit board
❐ Step 5: Install 700S Phase II Main Control assembly
❐ Step 6: Install Voltage Feedback circuit board
❐ Step 7: Install High Power Fiber Optic Interface circuit board
❐ Step 8: Install chassis fan
❐ Step 9: Connecting I/O and Communications
❐ Step 10: Document change