Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) - Manual (Page 6)

Publication 20C-IN001D-EN-P
6
4. Remove the four screws that secure the Fiber Optic Adapter bracket to the
drive. Save screws for reuse.
5. Remove the Fiber Optic Adapter bracket from the drive.
6. Disconnect the control power cable from X2 of the Fiber Optic Adapter
circuit board.
7. Disconnect the fiber-optic cables from right side of the circuit board, and
carefully set them aside.
8. Remove the four screws that secure the Fiber Optic Adapter circuit board to
the bracket and remove the Fiber Optic Adapter circuit board from the
bracket.
1
2
3
4
5
6
7
H1 through H7 sockets for
Fiber-Optic Cables
X2 Connects to 24V
dc Power