Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) - Manual (Page 8)

Publication 20C-IN001D-EN-P
8
1. Secure the two socket hinges (open end facing downward) to the 700S
control assembly mounting plate using the four screws provided.
2. Insert the two screws for the mounting bracket into the holes in the control
assembly mounting plate but do not tighten.
3. Slide the slots of the mounting bracket onto the screws on the control
assembly mounting plate and tighten the screws.
Open end facing
downward
Mounting plate
2.
3.
Mounting
bracket