Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) - Manual (Page 33)

33
Publication 20C-IN001D-EN-P
8. Secure the two hinge pins (pins facing upward) to the control frame using the
four screws provided.
9. Insert the two shoulder washers into the stop bracket and install the stop
bracket and insulation material with the two screws provided on the control
frame. Then, slide the 700S control assembly mounting plate onto the hinge
pins on the control frame.
Important: The insulation material must be installed between the control
frame and the stop bracket.
Pin end facing
upward
Control Frame
Shoulder washer
Screws
Insulation material
Stop bracket