Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) User Manual
Page 38
Publication 20C-IN001D-EN-P
38
Step 7: Installing 24V
Common Mode Filter Circuit
Board
The location of the 24V Common Mode Filter circuit board is different for
frame 10, 11 and 13 size drives versus frame 12 and 14 size drives. Refer to
“Frame 10, 11 & 13 Size Drives” below for frame 10, 11 and 13 size drives
installation instructions. Refer to “Frame 12 and 14 Size Drives” on
page 40
for
frame 12 and 14 size drives installation instructions.
Frame 10, 11 & 13 Size Drives
1. Install the four standoffs to the bottom of the 700S control mounting plate,
below the High Power Fiber Optic Interface board.
2. Secure the 24V Common Mode Filter board to the four standoffs using the
four screws provided.
Install 24V Common Mode Filter
board using four screws
=