Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) - Manual (Page 11)

11
Publication 20C-IN001D-EN-P
8. Route the 10 conductor ribbon cable, connected to P6 on the back of the
Main Control cassette, under the control frame.
9. Swing the Main Control mounting plate in to the frame and tighten the
captive screw to secure it to the control frame.
Step 6: Installing the
Voltage Feedback Circuit
Board 1. Secure the five small standoffs to the upper-left corner of the control frame.
Note: Main Control cassette not
shown for clarity only
Main control mounting plate
10 conductor ribbon cable
routed under control frame
Install five standoffs to
control frame