Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) - Manual (Page 23)

23
Publication 20C-IN001D-EN-P
Step 4: Installing the
Voltage Feedback Circuit
Board You must remove the airflow plate and the protective covers before you can
install the Voltage Feedback circuit board.
Removing the Airflow Plate and Protective Covers
1. Remove the T8 Torx-head screws that secure the airflow plate to the drive.
2. Slide the airflow plate off the enclosure frame.
Screws Screws
Frames 10…12 Frame 13 & 14