Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) - Manual (Page 35)

35
Publication 20C-IN001D-EN-P
11.Make the following connections on the 700S Phase II Control cassette:
– Connect the 10 conductor ribbon cable to P6
– Connect the 40 conductor ribbon cable to P1
– Connect the 30 conductor ribbon cable to P2
12.Slide the Phase II Main Control assembly onto the mounting bracket and
tighten the two mounting screws.
10 conductor ribbon cable
40 conductor ribbon cable
30 conductor ribbon cable
=
Note: Ribbon cables not
shown for clarity only