Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) - Manual (Page 31)

31
Publication 20C-IN001D-EN-P
5. Insert the plastic shoulder washers into the holes in the mounting plate and
secure the two socket hinges (open end facing downward) and insulation
material to the 700S control assembly mounting plate using the four screws
provided.
Important: The insulation material must be installed between the mounting
plate and the socket hinges as shown below.
Open end facing
downward.
Mounting plate
Shoulder washer
Screws
Insulation material
Socket hinge