Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) - Manual (Page 5)

5
Publication 20C-IN001D-EN-P
Step 4: Removing the
700H Fiber Optic Adapter
Circuit Board The Fiber Optic Adapter circuit board is located behind the 700H control
assembly on the opposite side of the control frame.
Important: Before removing connections and wires, mark the connections
and wires to avoid incorrect wiring during assembly.
1. If removing a control frame from a DC input drive with precharge interlock,
disconnect the wiring from terminal strip X50.
2. Remove the eight screws that secure the control frame to the drive. Save
screws for reuse.
3. Remove the control frame from the drive.
Note: Control frame shown without DPI/
HIM assembly for clarity only